e-PayDay Pty Ltd

ACTATek Bio-Clock installation and configuration

  1. Time and Attendance Installation Guide, read here.
  2. Set up your e-Time™ Import Configuration, read here.
  3. If not installed already, install SOAP 3.0 Toolkit
  4. Generate the Reference Report – Employees Only to obtain your Employees CLOCK ID to enter into the Bio-Clock
    1. Click Reports.
    2. Select Reference Report – Employees Only.
    3. Click Preview, Print or Export PDF.
  5. ACTAtek3 Manual, read here.
    1. Adding a User – Section 6.2……………………page 25.
    2. Activating User – Section 6.4.1………………..page 31.
    3. Auto-match fingerprints – Section 6.5.1…..page 33.
  6. e-PayDay® Bio-Clock™ Terminal
    1. Click Menu.
    2. Enter the Admin Login.
    3. Login ID: A999
    4. Login Password: 1
    5. Click Add User.
    6. Select Add Fingerprint OR Add Smartcard.
    7. Add Fingerprint
      1. Enter EmpClock ID (Found on Reference Report – Employees Only)
      2. Click OK.
      3. Scan Employee’s fingerprint 3 times. (same finger each time)
      4. The Employee is now registered.
      5. Click Back.
      6. Click Automatch.
      7. Enter the User ID (EmpClock ID).
      8. Click OK.
    8. Add Smartcard instructions
      1. Enter EmpClock ID (Found on Reference Report – Employees Only)
      2. Place the smartcard over the scanner and wait for success to be displayed.
  7. e-PayDay® Bio-Clock™ Web Interface
    1. Log into e-PayDay® Bio-Clock™ Web Interface via IP Address.
    2. Login ID: A999
    3. Login Password: 1
    4. Select Login Level: Super Administrator
    5. Click View User List.
    6. Click User ID.
    7. Enter First & Last Name.
    8. Click Modify.
    9. Repeat as necessary.
Revision: 7
Last modified: May 18, 2022