I would like to save the Hydrograph data from a Route Channel in one VO model and then use it for a READ HYD in another VO model. In the VO manual it says there is a “Save Hyd command located in the Hydrograph Data form”, but I can’t seem to find this. - Visual OTTHYMO

unfortunately, it is not possible to do it with VO 6 yet. You need to save the result. Afterward, use the following link to prepare a suitable format for “READ HYD”.

Hydrograph Files

I’m running a VO model with a DIVERT HYD command, and the output to each outlet does not match the input flow table.

The ADS system has multiple rows of chambers. However, VO asks for only 1 rating curve and outputs only 1 value for outflow. Is the software conceptualizing all the rows into a single row of chambers?