Different outputs are available for single-event simulation and continuous simulation.
Hydrograph is the main output from single-event simulation. The hydrograph is for only one event covering a few hours or days. VO provides five (5) different ways to view the hydrographs:
- Summary Data (table and label)
- Hydrograph Data
- Hydrograph Plot (single, cross scenario and plot calibration)
- Detailed Output
- Summary Output
Water balance is considered in the continuous simulation. The outputs are the long-term water balance and flow. VO provides two (2) output features to view continuous simulation outputs.
- Summary Data (table, pie chart and label)
- Time Series Plot (Single and Plot Calibration)
These output features can be found on the Simulation tab in the Output section. Access to these output features will be enabled after a successful simulation is run. Users will find that each feature has its use and at least one output feature will meet their needs for viewing output. A short description of each output feature is given as follows. More detailed information on each feature is contained within subsequent sections.
TABLE 10-1: OUTPUT FEATURES
| Output Feature | Description |
|---|---|
| Single-event | |
| Summary Data | This gives a summary table of key output data, based on objects selected by user. |
| Hydrograph Data | This gives a summary table of actual hydrograph points (time and flow) for the objects selected by the user. |
| Hydrograph Plot | This shows a graphical plot of the hydrograph(s) and run(s) as selected by the user. |
| Detailed Output | This shows the user the detailed text output file, which is familiar to previous users of OTTHYMO. |
| Summary Output | This shows the summary text output file, which is familiar to previous users of OTTHYMO. |
| Continuous | |
| Summary Data | This gives a summary of all water balance components. |
| Time Series Plot | This shows a graphical plot of the time series data and run(s) as selected by the user. |
