Mirror

With the Mirror command, objects are mirrored across an axis.

You can use existing objects or elements as a mirror axis, click/tap to define, measure with the Flexijet, or enter coordinates around which the objects should be mirrored.

To use this command:

1. Select the ‘Mirror’ command.
2. Select the objects to be mirrored, using the contextual selection buttons as needed, and confirm the selection with ‘Enter’ or the ‘Confirm’ button
3. Select the first and second points of the mirror access. These can be existing objects or elements as a mirror axis, click/tap to define, measure with the Flexijet, or enter coordinates around which the objects should be mirrored.
4. Now, the prompt will read ‘Delete old objects? [Yes/ No] :’ If you want to delete the old objects, then enter Y in the command line and press the Enter key. Otherwise, enter an N in the command line or just press the Enter key

The result:

The objects are mirrored.

!NOTE: On vertical planes, the ‘Mirror’ command will mirror based on a vertical axis that is based on the plan view of the drawing! Contact Flexijet Support for more information.