Checking if floor is solid or moving

Is the floor surface on which you’re setup stable or moving?

If you are not sure if you are on a stable surface, you can easily test it.

• Aim your Flexijet at a point: it could be anything on the wall, like a screw or a target sticker. (The further away, the better)
  
• Walk around your Flexijet while looking at the target.
  
• If you notice any movement on the laser dot, your floor is unstable.
  

If your floor is unstable:

Either setup the Flexijet in a different location, or use one of the remote controls to avoid moving the Flexijet while measuring.

*Hint: You can also use Tilt Monitoring to monitor if the Flexijet is moving during a measurement.