grandMA2

MIDI Show Control from the grandMA2 will trigger the Moving Light Assistant Cue List view as with grandMA 1 and EOS consoles. A USB MIDI interface can be used as well as sending the commands over ethernet (as with the grandMA 1).

Some MSC commands do not currently work correctly as the grandMA2 appears to not send correctly formatted MSC commands. The ‘Go’ and ‘Pause’ commands work fine, but the ‘Jump Forward/Back’ and ‘Resume’ commands do not work.

Below is a screen shot of the MIDI Show Control setup page as a starting point for setting up the MSC. You may need to adjust the settings depending on your setup.

grandMA2 Midi Show Control Dialog