Provides the ability to distort the layer and fold it into new shapes. The corners can be repositioned directly, and tangents attached to each corner can be used to modify the curvature of the sides.
It is generally easier to edit the bezier warp using the Viewer controls.
- Top Left: Assign a new position to the top left point of the layer or clip.
- Point: Specifies the location of the corner, using X (horizontal) and Y (vertical) values.
- | Tangent |: Defines the location of the handle at the end of the vertical tangent connected to the corner.
- – Tangent -: Defines the location of the handle at the end of the horizontal tangent connected to the corner.
- Top Right: Assign a new position to the top left point of the layer or clip.
- Point: Specifies the location of the corner, using X (horizontal) and Y (vertical) values.
- | Tangent |: Defines the location of the handle at the end of the vertical tangent connected to the corner.
- – Tangent -: Defines the location of the handle at the end of the horizontal tangent connected to the corner.
- Bottom Left: Assign a new position to the top left point of the layer or clip.
- Point: Specifies the location of the corner, using X (horizontal) and Y (vertical) values.
- | Tangent |: Defines the location of the handle at the end of the vertical tangent connected to the corner.
- – Tangent -: Defines the location of the handle at the end of the horizontal tangent connected to the corner.
- Bottom Right: Assign a new position to the top left point of the layer or clip.
- Point: Specifies the location of the corner, using X (horizontal) and Y (vertical) values.
- | Tangent |: Defines the location of the handle at the end of the vertical tangent connected to the corner.
- – Tangent -: Defines the location of the handle at the end of the horizontal tangent connected to the corner.