This article shows you how to use the GPI/O ports in the builder when using the FC-28 hardware.
- Find the FC-28 device
- Go to the devices tab and click on the menu
- Select browse devices
- Search for the FC-28 model
- Select the FC-28 device and click import
- Find the FC-28 feedback
- Go to the feedbacks tab and click on the menu
- Select browse feedbacks
- Search for the Kramer vendor
- Select the feedback and import it into your project
- Use the GPI/O commands and feedback
- These are the commands used for GPI/O
- These are the feedbacks used for GPI/O
- GPI/Os operate in three states. The following commands and feedback apply to each state:
- Digital In
- Command
- QUERY STATE
- Feedback
- GPIO STATE
- Command
- Digital Out
- Commands
- QUERY STATE
- SET STATE HIGH / LOW
- Feedback
- GPIO STATE
- Commands
- Analog In
- Commands
- QUERY STATE
- QUERY VOLTAGE
- Feedbacks
- GPIO STATE
- GPIO VOLTAGE
- Commands
- Digital In