Overview

Kramer Control supports control of KNX Lighting. Within this thread we will explain the builder configuration to properly setup your KNX device.

Builder

Before we proceed make sure the following steps have been completed

  1. Launch Builder
  2. Import KNX device

Create lighting alias following the correct address type. Examples are shown within the center pane, Three Level – Two Level or Custom Addresses

Chose Command you would like to execute

Add commands to widgets/macros/events

Hardware Setup

Add New Hardware gateway

Add device to new gateway, choose KNX type within properties window

Revision: 1
Last modified: Jul 25, 2017

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment