Refresh

Refresh function should be used to populate SCR calculation sheets that are read-only or can be used to populate QRTs.
So as SCR calculation results are read-only they can only be populated through data entered in the model entry sheets and then running the SII model refresh button.
To use this function go to Tabular ribbon -> Sii Model section -> Refresh

There are few Refresh options that can be selected:

- Refresh All – data will be updated in all SCR calculation sheets and QRTs of the current return

- Refresh Selected Sheet(s) – data will be updated only in selected sheets

- Refresh All QRTs – data will be updated in all QRTs of the current return

- Refresh All SCR calcs – data will be updated in all SCR calculation sheets of the current return

Every time after Refresh will run, B2 cell will be updated in those sheets that were refreshed with information that the sheet was refreshed, the user who run refresh, and the time of refresh.

In case sheet was excluded from the refresh function (see more information here) B2 sheet will also contain information but in this case, it will inform that sheet was excluded from a refresh, useed who excluded sheets, and time. And B2 will not be updated in you try to run refresh on this sheet.