Hide/Auto-unhide validation result in report

Hide from results

It is possible to hide the validation results from the validation report.
To hide validation result user should add a comment to it and select ‘Hide from results’ checkbox.

Note: Hidden validation results will still be included in the validation report. However, they will be hidden from view.

When the checkbox is selected this validation result will get status ‘Hidden by user’ and it will not be displayed after the next validation report run.

Auto-unhide if any values change

Auto-unhide if any values change checkbox is enabled only in case ‘Hide from results’ checkbox is selected too.
In case value of datapoint for this validation report was changed and Auto-unhide if any values change checkbox was selected in comment, then validation result will be visible again and the comment will be highlighted in RED. Status of validation result will be ‘Hidden by user but value changed’
User can Re-Affirm this comment, so comment will be updated and hidden again after the next validation report run.

Note: If “Auto-unhide’ checkbox is not selected validation result will not be visible again after value change.

Global configuration

Default settings of Hide/Auto-unhide validation result can setted up via Tools -> Settings -> System Options

So each time user will be adding new comments by default it will be created with default settings that were set up there.