Automatically Enable DMX on Component Start
When On, the DMX component will receive DMX immediately on Engine startup.
When Off the DMX component will not receive DMX on Engine startup.
Enable Smoothing
When On Float pins (pins that go from 0-1 eg Layer Level) will fade based on the smoothness time. (0-500 milliseconds). This function is used to compensate for uneven control signals or slow Art-Net refresh rates.
Monitor Frequency
Determines how often numbers are re-drawn the DMX monitor window.
Art-Net (sACN)
Contains settings for receiving Art-Net and sACN.
Use Host Network Adaptor
When on Art-Net will be read from the same network interface as the host [Engine].
When off a network adaptor must be specified.
| Note: Art-Net requires a 2.xxx.xxx.xxx or 10.xxx.xxx.xxx IP address to function. |
Accept Data from any IP Address
When on data from any source IP address will be used.
When off only data from specified sources will be used.
The default of receiving data from all IP addresses is the most common case; specifying sources is usually used on only the most complex networks.
MA-Net
Hippotizer will listen to MA-Net data as a passive node. It will consume parameters as a normal fixture. Hippotizer supports Grand MA 2 version 2.9 software and above.
Use Host Network Adaptor
When on MA-Net will be read from the same network interface as the host [Engine].
When off a network adaptor must be specified.
| Note: MA-Net frequently uses very similar IP addresses to Hippotizer, take care to always separate MA and Hippo Networks physically and in addressing. |
Session ID
Specify which MA Session to listen to.
Post your comment on this topic.