A Video Map is comprised of tiles. A tile normally corresponds to the resolution of a video wall panel.
To create tiles, use the Add Tiles Dialogue.
Tile Width and Height
The size in pixels of the tiles to be created
Layout
The number of tiles to be created. By default, new tiles are created in a grid with a number of rows and columns. Tiles can be re-arranged after they are created.
Position
The location of the top left corner of the array of tiles
Numbering
The starting number of the tiles. By default this is the next available number.
The numbering can be set Left To Right or Top to Bottom:
Left to Right
Number starting at the top left corner and works to the right increasing along the row. At the end of a row, the numbering jumps to the next row down.
Top to Bottom
Numbering starts at the top left and travels down each column before shifting one row right and moving down again.
Allow Overlaps
When enabled, two tiles may have the same Colour blocks index.
Once added, tiles can be arranged by dragging them or by setting the position in the tile properties.
Post your comment on this topic.