Below you will find the ports necessary for communicating with the Kramer Control servers. If your network has any restrictions on these ports you may run into issues with saving, publishing, control, remote access or dashboard events. All traffic within the ports listed below is Outbound Only.
|User Interface Assets
|Secured Rabbit Messages
|NTP System Time
|Non-external access, Internal Network only
|Brain Identification used for Referenced Devices, Internal Network Only
If the “hostnames” provided are not sufficient enough for the firewall that has been installed, you can identify the IP address of the hostname by running either of these commands thru Command Line
- Follow this link to webpage
Substitute with the name found in the host section boxes above.