During an agricultural operation within a field, situations in which the input being used depletes – spray syrup, fertilizers, seeds, etc., are quite common. – in the middle of one of the guide lines. For operations that do not leave visible marks on the ground, such as spraying in an area with plants already grown, it becomes difficult for the operator to return to the same point at which the input ended without having any visual reference.
For these situations, the system GeoNave it has the Navigation Pause function, in which a pause point is marked on the navigation map, which helps the operator to return to the same position where the input ended after carrying out the refueling.
On the navigation screen, when there is an active tab, to pause navigation the user must press the pause button 
. The screen for Information with Confirmation for the user to confirm the pause by the confirm button 
, as in the figure below. If you press the cancel button 
, the pause is not performed and returns to the previous screen.
Upon confirming the pause, only the last target guide on which the pause was made, in solid red line, and the deviation from Header will be calculated in relation to it. Enter the pause point, marked on the screen in red and identified by the letter P, and the triangle that represents the tractor will have a dashed line, indicating the direction of the point, and an information box will be shown with the distance to the point of the pause in the format P: Distance, as shown in the following image.
After returning to the place where the pause point was marked, to exit the pause state the user must press the resume navigation button 
. The screen for Information with Confirmation for the user to confirm the resumption of navigation by the confirm button , as shown in the following figure. Pressing the cancel button , the pause will be maintained and you will be returned to the previous screen.
After confirmation, the navigation screen will return to its conventional state.
