GeoNave 30

5.4. Diagnosis

To verify that the system installation ISO 30 was performed correctly, the sequence described below must be followed.

  1. Make sure that the antenna GNSS is in a location with a view of the satellites, without obstructions;
  2. Turn on the monitor GeoNave;
  3. Access the screen Information> Satellites;
  4. Check that the screen data was filled close to the ideal values, according to the table below.
Information Value
Data from GPS GPS internal 1
Signal Quality Great
HDOP Less than 1.0
Used Satellites Greater than or equal to8
Longitude Value between -180.00000000 and +180.00000000
Latitude Value between -90.00000000 and +90.00000000

1 When the terrain compensating accessory is present, a GPS external.