The Lateral Offset parameter is used to configure the misalignment that exists between the center point of the implement and the longitudinal axis of the tractor. In operations with signal correction of GNSS IsoPoint 3 and IsoPoint 4, the lateral displacement is a very important configuration to avoid flaws and overlaps in the application in parallel guides. Especially in these cases, the displacement value must be measured with the aid of a measuring tape.
Measured in meters, the value of the lateral displacement can be positive or negative. Positive values represent that the center of the implement is offset to the right of the tractor axis. Negative values mean that the center of the implement is to the left of the axis.
The image below shows the configuration screen for the Lateral Displacement parameter, including the self-explanatory figure of its meaning.
