GeoNave 30

4.1. Monitor GeoNave

Technical Data

Display LCD TFT active matrix
RGB
7”(152 × 91 mm)
800×480 pixels
Processor ARM Cortex M4
180 MHz
RAM 64MB SDRAM
Storage 8GB
Approximate weight 1200 g
Temperature -20 ~ 70 ° C
Supply voltage 9~ 16 V
Maximum current 42THE
Maximum Current in stand by < 100 mA
Interfaces 2x CAN 2.0B / J1939
1x USB 2.0
1x RS232
Appetizer 4x Digital inputs / frequency NPN/ PNP (configurable via software), max. 200 mA
1x Function input wake up
3× 4-20 mA analog inputs (license dependent function)
2x Different analog inputs (24-bit A / D converter) for scale (license dependent function)
Outputs 4x Outputs high side 12VREF, max. 2 A
1× 5VREF output, max. 1 A
11x H bridge outputs for spray valves, max. 3.5 A peak (license dependent function)
GNSS GPS+ GLONASS L1
Cabinet ABS
Degree of protection IP65

Dimensions

The figure below shows the dimensions of the monitor GeoNave, with values ​​in mm.

Connectors

The monitor GeoNave it has 6 connectors, 5 of them arranged on the rear face of the case, and 1 connector on the right side. The following image describes the connectors.

Connector description
A Power connector, circular 14-pin model.
B Valve and sensor connector, 18-pin circular model.
  • Note: Compatible with cable connector labeled CX-8.
C Valve and sensor connector, 18-pin circular model.
  • Note: Compatible with cable connector labeled CX-9.
D Communication connector, circular 12-pin model.
E Antenna connector GNSS, model TNC 50 Ω.
Connector for portable memory, model USB 2.0.