To Guide Type configured as Curve, the guide lines are created parallel to each other, so that any point on a guide will be far from the same value in relation to the adjacent curve in the field, which makes the design of each parallel line different from each other. The distance between the guides is always the difference between the width of the Implement and the Overlay.
The curved guides exist only in the space between points A and B, they are not extended to infinity as is done for straight guides. The image below illustrates an example of curved guides for a field.
On the Navigation, initially press the button to mark point A 
. At Map Area, a red dot will appear, identified by the letter THE. Between this point and the triangle that illustrates the tractor there will be a red dashed line, which represents the path taken since the point A. Alert Board with information Point A: OK. The figure below shows the screen for marking point A of the curved guide.
After moving more than 20 meters from point A, the button for marking point B will be available on the navigation screen. If the button is pressed, the Loading with the information that the current tab is being saved, then returning to navigation. The point THE on the screen, previously marked in red, it will take on a dark blue color. The light blue dot identified by the letter will also appear B. The zero index curved guide will then be defined, and the navigation screen will show the guide lines as shown in the topic Guides. Also presented is a Alert Board with information Point B: OK
If the distance between points A and B is too large, it is possible that a Alert Board with the message Calculando Curvas Paralelas… Aguarde, while parallel curves are calculated by the system. The same behavior can arise if the guide lines are quickly traversed in the direction perpendicular to them.
