English
- Português
- Español

GeoNave 30

1

Table of Contents

GeoNave 30

1
- GeoNave 30 — 1

1. Introduction
- 1.1. What is the GeoNave?
- 1.2. Licenses
2. System Components
3. Security instructions
- 3.1. Recommended Use
- 3.2. Cleanliness and conservation
- 3.3. Disposal of Components
4. Technical Data
- 4.1. Monitor GeoNave
- 4.2. GNSS
5. Installation
- 5.1. Monitor Fixation
- 5.2. Antenna GNSS
- 5.3. Connections
- 5.4. Diagnosis
6. Fundamentals of GeoNave
- 6.1. Turn on and turn off
- 6.2. Touch Sensitive Buttons
- 6.3. Configuration Screens
- 6.4. Navigation Screen
- 6.5. Light Bar
- 6.6. Application Button
- 6.7. Autopilot Button
7. Information Menu
- 7.1. Satellites
- 7.2. Equipment
8. Settings menu
- 8.1. Pulverization
- 8.2. Job
- 8.3. Pilot
- 8.4. Fertilizing
- 8.5. Memory
- 8.6. settings RTK
  - 8.6.1. Operation mode
    - 8.6.1.1. Base
    - 8.6.1.2. Rover
      - 8.6.1.2.1. Current Time
      - 8.6.1.2.2. Flicker Prediction
- 8.7. Advanced
9. Navigation Menu
- 9.1. Create Field
- 9.2. Open Event
- 9.3. Configuration Summary
10. Operation
- 10.1. Configure a Machine
- 10.2. Start a Job
- 10.3. End a Job
- 10.4. Create a Guide
- 10.5. Adjust Position
- 10.6. Pause / Resume Navigation
- 10.7. Configure the Lightbar
- 10.8. Create a Boundary
- 10.9. Turn on / off the Trail
- 10.10. Toggle 2D / 3D View
- 10.11. Adjust the Brightness
- 10.12. Change Color Scheme
- 10.13. Display Signal Quality GNSS
- 10.14. Configure the Terrain Compensator
- 10.15. Performing an Irrigation
11. Firmware Update
12. Platform IsoFarm
- 12.1. Create an account IsoFarm
- 12.2. Change Password IsoFarm
- 12.3. Password recovery
- 12.4. Import an event from GeoNave
- 12.5. Viewing an Event GeoNave
13. Problems and Solutions
14. Support and Technical Assistance
15. Warranty Terms
16. Declaration of Conformity
17. Glossary
18. Contact
19. Revision control

Download as PDF

8.6.1.1. Base

Correction Protocol
Visible Constellations
Base Used

When the Operation Mode parameter is set to Base, the Configuration menu RTK is shown containing the items in the following figure.

Copyright © 2025 Agres Sistemas Eletronicos — Powered by