In this area the user gets information to make a self-diagnosis of possible problems with the system GeoNave ISO 30.
| Problem |
Possible solutions |
| The monitor does not turn on. |
- Check the correct connection of the cable to the tractor battery.
- Check the integrity of the fuse in the battery cable.
- Check the correct and fixed connection of the power cable to the battery cable.
- Check the correct and fixed connection of the power cable to the monitor.
- Check if any of the cables are broken.
|
| Touch screen does not respond. |
|
| Signal GNSS weak or absent. |
- Ensure that the antenna GNSS is aimed at the open sky. Obstructed places can deteriorate the signal GNSS.
- Check the correct installation of the antenna GNSS on the tractor roof.
- Check the integrity of the antenna cable GNSS, if there are no breaks or folds.
- Using a multimeter, check the 5 V voltage present on the antenna cable GNSS.
- If the antenna GNSS is close to dense forest areas, disable the Signal Filter GPS. Note: Positioning accuracy is degraded by forest obstructions.
|
| Portable memory is not recognized. |
- Ensure that the size of the portable memory is not larger than 8 GB.
- Format the memory as FAT32 and standard allocation size, as described in the Firmware Update.
|
| Spray valves and sensors cannot be configured |
- Contact the commercial area to purchase the kit and the Spray license according to your machine.
|
| Unable to access the Fertilization menu |
- Contact the commercial area to purchase the kit and the fertilization license according to your machine.
|
| Unable to access the Pilot menu |
- Contact the commercial area to purchase the autopilot kit and license according to your machine.
|
If any of the problems listed above persist, contact the team Support and Technical Assistance for the correct diagnosis.
