This section describes how to set up conveyor zones with two motor rollers in scenarios involving ZPA Mode, PLC I/O Mode, and ConveyLogix program control. The details of the set up are also governed by the mechanical construction of the conveyor zone.
Solution Matrix for ConveyLinx-ERSC Family Modules
| Zone Type | Operational Mode | Solution |
|---|---|---|
| 2 MDRs – Coupled | ZPA | Requires set-up in EasyRoll |
| PLC I/O | Requires program code to set up proper PLC Output Assembly values | |
| ConveyLogix | Requires program code to set up proper internal register values | |
| 2 MDRs – Non-Coupled | ZPA | Not required to be set-up in Easy-Roll, but can be |
| PLC I/O | No special adjustments required – Use program code to run independently or together as desired | |
| ConveyLogix | No special adjustments required – Use program code to run independently or together as desired | |
| 2 Motors in 1 MDR Tube | ZPA | Requires set-up in EasyRoll |
| PLC I/O | Requires program code to set up proper PLC Output Assembly values | |
| ConveyLogix | Requires program code to set up proper internal register values |