![]()
Each Sensor and Control Port is a standard RJ-12 style jack.
Sensor Port Pin Out
Pin |
Signal |
Description |
---|
1 |
|
Not Used |
2 |
GND |
Module DC Common |
3 |
Sensor Error |
Digital Input for Sensor’s error output – Auto detect for NPN or PNP |
4 |
Sensor State |
Digital Input for Sensor’s state output – Auto detect for NPN or PNP |
5 |
Vcc |
Module 24VDC Supply |
6 |
|
Not Used |
!Shorting Pins 2 & 5 (Vcc and Gnd) may damage the port’s Sensor Detect circuit. If this circuit is damaged, the module will no longer properly detect a connected sensor and will not properly Auto-Configure.
Control Port Pin Out
Pin |
Signal |
Description |
---|
1 |
Output E |
Digital Output for Upstream/Downstream Interlock, SE Module recommended |
2 |
GND |
Module DC Common |
3 |
P3 Input |
Optional Local Accumulate Digital Input – Auto detect for NPN or PNP |
4 |
P4 Input |
Optional Interlock Digital Input – Auto detect for NPN or PNP |
5 |
Vcc |
Module 24VDC Supply |
6 |
Output C |
Digital Output for Upstream/Downstream Interlock, SE Module recommended |
!Single output signal flows between Pin 1 and Pin 6. This signal is very low power (@ 2mA). An SE Breakout Module is recommended when using of this signal.