When using the Generic Ethernet Module construct in RSLogix 5000, you must supply configuration information about the device you are trying to connect. The following sections show the step by step procedure to connect a ConveyLinx-Ai Family Modules for each set of Input and Output Assemblies described in the PLC Developers Guide section.
| Assembly | Recognized Instance Values |
|---|---|
| ZPA Mode Assembly Inputs | 105 |
| ZPA Mode Assembly Outputs | 106 |
| ZPA Mode Assembly Inputs with Reset Protection | 305 |
| ZPA Mode Assembly Outputs with Reset Protection | 306 |
| Reduced Size ZPA Mode Assembly Inputs | 119 |
| Reduced Size ZPA Mode Assembly Outputs | 120 |
| Reduced Size ZPA Mode Assembly Inputs with Reset Protection | 319 |
| Reduced Size ZPA Mode Assembly Outputs with Reset Protection | 320 |
| PLC I/O Mode Assembly Inputs | 107 |
| PLC I/O Mode Assembly Outputs | 108 |
| PLC I/O Mode Assembly Inputs with Reset Protection | 307 |
| PLC I/O Mode Assembly Outputs with Reset Protection | 308 |
| Reduced Size PLC I/O Mode Assembly Inputs | 117 |
| Reduced Size PLC I/O Mode Assembly Outputs | 118 |
| Reduced Size PLC I/O Mode Assembly Inputs with Reset Protection | 317 |
| Reduced Size PLC I/O Mode Assembly Outputs with Reset Protection | 318 |
| ConveyLogix Assembly Inputs | 121 |
| ConveyLogix Assembly Outputs | 122 |