This section describes how to set up conveyor zones with two motor rollers in scenarios involving ZPA Mode, PLC I/O Mode, and ConveyLogix program control. The details of the set up are also governed by the mechanical construction of the conveyor zone.
Solution Matrix for ConveyLinx-Ai Family Modules
Zone Type | Operational Mode | Solution |
---|---|---|
2 MDRs – Coupled | ZPA | Automatic – No Adjustments required |
PLC I/O | Requires program code to set up proper PLC Output Assembly values | |
ConveyLogix | Requires program code to set up proper internal register values | |
2 MDRs – Non-Coupled | ZPA | Will Not Work Properly |
PLC I/O | No special adjustments required – Use program code to run independently or together as desired | |
ConveyLogix | No special adjustments required – Use program code to run independently or together as desired | |
2 Motors in 1 MDR Tube | ZPA | Not Possible |
PLC I/O | Requires program code to set up proper PLC Output Assembly values | |
ConveyLogix | Requires program code to set up proper internal register values |