Before the Auto-Configuration Procedure can be performed; each individual ConveyLinx-Ai Family Modules needs to have its associated MDR’s and photo-sensors connected in the proper way for expected operational results.
In general, each ConveyLinx-Ai Family Modules detects which Sensor ports have a device connected and will use this to determine its specific configuration once it has been instructed to self-configure by the Auto-Configuration Procedure.
Before starting to configure your system to operate, each MDR and photo-sensor needs to be properly connected to the ConveyLinx-Ai Family Moduless mounted on the conveyor. Modules will determine how to operate based upon how the photo-sensors and MDR’s are connected.
A single ConveyLinx-Ai Family Modules can operate as a:
| 2 zone controller with 2 MDR’s and 2 photo-sensors |  |
| 1 zone controller with 1 MDR and 1 photo-sensor on Left or Right Side |  |
| 1 zone controller with 2 MDR’s and 1 photo-sensor with Sensor on Left or Right Side |  |