Rotate

With the ‘Rotate’ command, objects are rotated around a selected point.

Note that this command is used to rotate elements on the canvas. To change the entire canvas view, use Align to set the horizontal alignment.

To rotate elements:

• Select the ‘Rotate’ command from the ‘Change’ ribbon or from the right-click menu.
  
• Select the element(s) to be rotated, then press ‘Confirm’ or ‘Enter’.
• Now, select the base point of rotation, the point around which the elements will be rotated.
• Now, enter the rotation angle, then press ‘Confirm’ or ‘Enter’

*Note: Only the selected elements are rotated! Measured points are not rotated with the elements unless these points are displayed using ‘Show Measurement Points’ and selected during the ‘Rotate’ command. Recommend using ‘Align’ to rotate the view of the page.