Break 2 points

The ‘Break 2 points’ function is used to break an object between two points.

to use this function:

• Select the ‘Break 2 points’ button from the drop-down underneath ‘Break at a line’
  
• Select the object you wish to break. (Note: confirmation by clicking ‘confirm’ or ‘enter’ not required)
• Click or tap to select the first breakpoint, then the 2nd breakpoint. The element is broken between the 2 points, and the section between these points is removed.
• The function runs continuously, so now select a new element to be broken from step 2, or press ‘Confirm’ or ‘Cancel’ to end the function.

To break at a single point, use ‘Break at a point’