Break at a line

The ‘Break at a line’ function is used to break all objects that are transected by a line.

• Select the ‘Break at a line’ button from the Change ribbon.
  
• Select the line at which all transecting objects should be broken_(Note: confirmation by clicking ‘confirm’ or ‘enter’ not required)_
• The command window will read out the results: ’2 Object(s) broken at 4 point(s)’.
• The function runs continuously, so you may now select a new line as in step 2, or press ‘Confirm’ or ‘Cancel’ to end the function.
  

To break between 2 points, use ‘Break 2 points’.
To break at a single point, use ‘Break at a point’