Mirror

With the Mirror command, objects are mirrored across an axis.

You can use existing objects or elements as a mirror axis, click/tap to define, measure with the Flexijet, or enter coordinates around which the objects should be mirrored.

To use this command:

• Select the ‘Mirror’ command from the change ribbon.
  
• Select the objects to be mirrored, using the contextual selection buttons as needed, and confirm the selection with ‘Enter’ or the ‘Confirm’ button
• Select the first and second points of the mirror axis. These can be existing objects or elements as a mirror axis. Click/tap to define, measure with the Flexijet, or enter coordinates around which the objects should be mirrored.
• Now, the prompt will read ‘Delete old objects? [Yes/ No] :’ If you want to delete the old objects, then enter Y in the command line and press the Enter key. Otherwise, enter an N in the command line or just press the Enter key

The result:

The objects are mirrored.

!NOTE: On vertical planes, the ‘Mirror’ command will mirror based on a vertical axis that is based on the plan view of the drawing! Contact Flexijet Support for more information.