Flexijet Fine Drive

As is known with tachymeters, a fine drive can be used to move to points precisely. However, since we cannot retrofit mechanical fine drives, this was implemented via software.

To start the fine drive mode:

• A drawing command must be active

• Then the scroll wheel must be pressed for a long time (approx. 3s).
  
• An icon can be seen in the Flexijet status bar.
  
• When the ring around the symbol is full, the function is activated and shown on the display as follows:
  
• The step size is adjustable and can be adjusted as required. When starting the fine adjustment, the vertical axis is always active first. This can be seen by the red arrow pointing up/down.
• To move in the active axis, the scroll wheel must be turned.
  
• To change the direction, tap the symbol with the red and white arrows. The red arrows display the corresponding other axis.