Introduction to Flexijet Stone

• Click here to learn about connecting to Flexijet 3D.
• Click here for information about Setting Up Flexijet Stone.

Opening Flexijet Stone:

• Double Click on the ‘Flexijet Stone’ icon
  

• The General Preference panel will open. If connecting to Flexijet, ensure that ‘Flexijet 3D 2’ is selected. You may also choose between PC Mode and Touch Mode
  

• If this is the first time opening Flexijet Stone 4, the software will ask you for a company key. Please contact Flexijet Support 1-844-MY-FLEXI Ext 2 (1-844-693-5394) for assistance.

• If your company key is been already activated,Flexijet Stone 4 software will now load.

The layout and sections of Flexijet Stone:

• Top controls and Ribbon
  This is where most of the functions used to control Flexijet and draw/edit in Flexijet Stone/FlexiCAD are located and organized into tabs/ribbons.
  The left 12 Quick-Access buttons are visible on all ribbons.

• Project Explorer and Properties
  The Folders/planes created will be available here and can be selected by clicking on the folder’s text. The checkboxes next to the folders turn visibility for other folders on/off.
  The Properties pane allows for the editing of selected elements or of the pen to define elements to be measured or drawn.

• Canvas (work Area)
  The measurement drawing will be created and edited in the Canvas area. About navigating in Flexijet Stone

• Command Window & Bottom controls (View and Transport)
  Messages and prompts relating to the active functions will appear in the Command Window.