Offline System / Module Configuration Screen Tabs /
Sensors
The Sensors tab displays the status of how the two sensor signals were configured during the Auto Configuration Procedure. If for some reason one or more of the sensors was not configured properly during the Auto Configuration Procedure, the Sensors Tab will allow you to change the sensor’s configuration without re-performing the Auto Configuration Procedure again for the entire subnet. For example: the sensors were not aligned with their reflector, or there was an obstruction blocking the sensor at the time the procedure was performed.
| Note that you can make the same change for a group of modules by clicking the Set All Sensors this Way button |  |
Additionally, if all the sensors on the system are light energized normally open, then the corresponding zone’s sensor graphic on this tab will show Off Blocked. Click the appropriate icon to change either or both sensor’s blocked signal state.
Post your comment on this topic.