Appendix

Last Zone Recommendation	ConveyLinx ERSC ✅	ConveyLinx-Ai 24V ✅	ConveyLinx-Ai 48V ✅
	ConveyLinx-ECO ✅	ZPA Mode ✅	PLC I/O Mode ❌

On the last zone of a ZPA conveyor, it is recommended to check “Disable Arrival Jam Reset Delay” and “Disable Arrival Timeout”.
Checking these two options will prevent the last module from jamming after each discharge.

*This is not required if you are using a lane full sensor, or using a PLC to send an arrival confirmation.