Module Configuration Screen Tabs / Sensors /


ConveyLinx-ECO

ConveyLinx ERSC ConveyLinx-Ai 24V ConveyLinx-Ai 48V
ConveyLinx-ECO ZPA Mode PLC I/O Mode


The ConveyLinx ECO Family modules display the status of how the two sensor signals were configured during the Auto Configuration Procedure. They have the below settings available for configuration. The right sensor will handle the right side of the module, and the left sensor will handle the left side of the module.

Click the appropriate toggle to change either or both sensor’s blocked signal state, or their Aux State on Blocked. View their Sensor Error Counter, or their Sensor Debounce Timer. Note that you can make the same change for a group of modules by clicking the Set All button

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Please do not use this for support questions.
Pulseroller Contact Page

Post Comment