EasyRoll+ User Manual
1
1
Table of Contents
EasyRoll+ User Manual
1
EasyRoll+ User Manual — 1
Applicable Products Using EasyRoll+
About This Manual
Glossary of Terms
Installing EasyRoll+
Connecting Your PC to the Network
Offline System
Projects
Subnets
Configure Modules
Main
General I/P
Configuration
Motors
ConveyLinx-ERSC Family
ConveyLinx-Ai/Ai2/Ai3 24V Family
Conveylinx-Ai2/Ai3 48V Family
ConveyLinx-ECO
Sensors
ConveyLinx-ERSC Family
ConveyLinx-Ai2/Ai3 Family
Zones
ZPA Mode
Look Ahead
Jam & Auto Clear
Run After & Induct
Additional Settings
Disable Reset Delays
Disable Sensor Jam Auto Clear
Disable Arrival Timeout
Disable Manual Operation
ConveyMerge
ConveyMerge Prerequisites and Requirements
Network Architecture
Sensor Placement
Merge Zone Module
Merging Lines
Merge Configurations
Merge Priority
T-Merge Settings
Configuring Dynamic Priority Release
Enabling ConveyMerge from EasyRoll
Conventional Spur Merge Example
T-Merge Example
Merge Line Full Example
Control Ports
Logical Connections
Online System
Network Adapters
Discover & Draw Topology
Analyze Network
Commission from Project
Access via VPN
ProfiNet Domain
Backup Viewer
Firmware
ConveyLogix
EasyRoll Software
Main Screen
Node Navigation
Node Identification
ZPA Upstream/Downstream Zone Settings
ZPA Error and Information
Accumulate Control from Main Screen
Motor Settings
Motor Type
Brake Method
Speed
Rotation Direction
Acceleration/Deceleration
Motor Jog and Error Indicators
PGD Motor Pulse Distance Calculation
Diagnostic Window
Advanced Dialog
Upgrade Tab
Connections Tab
Network Services Tab
Discover & IP Address Set
Backup & Restore
Special Services Tab
Extensions Tab
Pin 2 Usage Tab
Most Downstream Zone
Most Upstream Zone
Accumulate Intermediate Zone
Lane Full Interface
Most Upstream Zone Handshake Interlock
Most Downstream Zone Handshake Interlock
Inverting the Pin 2 Signals
Appendix
Jam Conditions
Flex Zone
Brake Method
Sensor Debounce
Look Ahead Slow Down
Run After
Induct Forward & Reverse
Touch & Go
Last Zone Recommendation
Motor Rotation
ConveyLinx Ethernet Definition
Node Connections for a Subnet
Auto-Configuration Procedure
Expected Results
Configure Modules
Subnets
Main
Feedback
Was this helpful?
Yes
No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
×
Thanks for your feedback.
Post your comment on this topic.
Your name *
Your e-mail address *
Comment *
Post Comment
Post your comment on this topic.