Offline System / Module Configuration Screen Tabs / Motors /


Conveylinx-Ai2/Ai3 48V Family

ConveyLinx ERSC ConveyLinx-Ai 24V ConveyLinx-Ai 48V
ConveyLinx-ECO ZPA Mode PLC I/O Mode


Item Function Description
Motor Type ● Dropdown of Motor Types
● Each type is related to motor performance
● list shows only types available for the controller being viewed
7% Overspeed ● Checkbox to enable the speed to be 7% faster than the configured speed setting
Motor Direction ● Selects either Clockwise or Counterclokwise
● See Motor Rotation in Appendix for more information
Brake Method ● Dropdown of Holding Brake Methods
● List shows only types available for the controller being viewed
● See Brake Method in Appendix for more information
Speed ● Value input box to enter desired speed
● Motor speed value is in m/sec
● Valid max and min speeds are encoded into the motor roller and read by the ConveyLinx module
Use G-Force ● When checked, motor accel / decel is based upon constant G-force
● With this setting enabled the accel time and distance is variable
Acceleration ● Value input box to enter desired acceleration value
● When Use G-Force is unchecked, the value is distance in mm
● When Use G-Force is checked, the value is in m/sec²
Deceleration ● Value input box to enter desired deceleration value
● When Use G-Force is unchecked, the value is distance in mm
● When Use G-Force is checked, the value is in m/sec²
Set All ● Click button to apply these settings to a range of modules.
● Pop-up dialogue box will provide list of other controllers to apply the settings to
● Settings will only apply to the side of the controller (Left or Right) for which you are changing settings

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment