When the Guide Pattern is configured as Curve, the guide lines are created parallel to each other, this way any point on a guide will be at the same distance to the adjacent curve in the field, which makes the design of each parallel lines different. The distance between the guides is always the difference between the Implement width and the Overlap.
Curved guides exist only in the space between points A and B, they are not extended to infinity as is done for straight guides. The image below illustrates an example of curved guides.
On the Navigation screen, initially press the button to mark point A 
. A red dot will appear in the Map Area, identified by the letter A. Between this point and the triangle that represents the tractor there will be a straight dashed red line, which represents the path taken since marking point A. In addition, an Alert Board with information Point A: OK will be displayed, as shown in the image below.
After moving more than 20 meters from point A, the button for marking point B 
will be available on the navigation screen. If the button is pressed, the Loading screen will be shown with the information that the current guide is being saved, then returning to navigation screen. The point A, previously marked in red, will turn dark blue color. A light blue point identified by the letter B will also appear. The curved guide identified with the number 0 will then be defined and the navigation screen will display the guide lines as shown in the topic Guides. Will be also presented an Alert Board with information Point B: OK
If the distance between points A and B is very large, it is possible that an Alert Board with the message Calculating Parallel Curves … Please wait will be displayed, while parallel curves are calculated by the system. The same behavior can happen if the guide lines are quickly traveled in its perpendicular direction.
