English
- Português
- Español

GeoNave 31

1

Table of Contents

GeoNave 31

1
- GeoNave 31 — 1

1. Introduction
- 1.1. What is the GeoNave?
- 1.2. Licenses
2. System Components
3. Security Instructions
- 3.1. Recommended Use
- 3.2. Cleanliness and Care
- 3.3. Disposal of Components
4. Technical Data
- 4.1. GeoNave Display
- 4.2. GNSS
5. Installation
- 5.1. Display Fixation
- 5.2. GNSS Antenna
- 5.3. Connections
- 5.4. Diagnosis
6. GeoNave basics
- 6.1. Switching ON and OFF
- 6.2. Touch sensitive buttons
- 6.3. Configuration screens
- 6.4. Navigation screen
- 6.5. Guidance lightbar
- 6.6. Application button
- 6.7. Autopilot button
7. Information Menu
- 7.1. Satellites
- 7.2. Equipment
8. Settings Menu
- 8.1. Spraying
- 8.2. Work
- 8.3. Auto Steering
- 8.4. Fertilization
- 8.5. Memory
- 8.6. RTK Configuration
  - 8.6.1. Operation mode
    - 8.6.1.1. Base
    - 8.6.1.2. Rover
      - 8.6.1.2.1. Current Time
      - 8.6.1.2.2. Scintillation Forecast
- 8.7. Advanced
- 8.8. Orchard
9. Navigation Menu
- 9.1. Build Field
- 9.2. Open Event
- 9.3. Configuration Summary
10. Operation
- 10.1. Machine setting
- 10.2. Starting a Work
- 10.3. Ending a Work
- 10.4. Create a Guide
- 10.5. Position Adjustment
- 10.6. Pause/Resume Navigation
- 10.7. Lightbar setting
- 10.8. Create a Boundary
- 10.9. Main Sprayer Switch on/off
- 10.10. Toggle 2D/3D View
- 10.11. Brightness setting
- 10.12. Change Color Scheme
- 10.13. Display GNSS Signal Quality
- 10.14. Terrain Compensator setting
- 10.15. Performing an Irrigation
- 10.16. Sprayer Tank Filling
- 10.17. Changing the Sprayer Tank Level
11. Firmware Update
12. IsoFarm Platform
- 12.1. Create an IsoFarm account
- 12.2. Password recovery
- 12.3. Change IsoFarm Password
- 12.4. Import an event from GeoNave
- 12.5. Viewing an event from GeoNave
13. Problems and Solutions
14. Support and Technical Assistance
15. Warranty terms & conditions
16. Declaration of Conformity
17. Glossary
18. Contact
19. Revision control

Download as PDF

8.6.1.1. Base

Correction Protocol
Visible constellations
Base used

When the Operation Mode parameter is set to Base, the RTK Configuration menu contains the items shown in the following image.

Copyright © 2025 Agres Sistemas Eletronicos — Powered by