When the Guide Pattern parameter is configured as Free, the user can generate the guides directly through the path taken by the machine in the field, allowing the user to create as many guide lines as necessary. In this guide pattern, the distance between the guides is not defined by the implement width and overlap parameters as for Straight and Curve guide patterns.
The image below shows an example of Free guide pattern.
On the Navigation screen, initially press the button to mark point A 
. A solid blue line will be drawn in Map Area following the path taken by the tractor from point A marked. In addition, an Alert Board with information Point A: OK will be displayed, as shown in the image below.
After moving more than 20 meters from point A, the button for marking point B 
will be available on the navigation screen. If the button is pressed, an Alert Board with information Point B: OK will be displayed. This way, the first free guide will be defined, and the guide line will continue to be shown in blue until the end of the marking, which is done by pressing the finish free guide button 
.
After pressing point A, it is possible at any time to cancel the current line marking by pressing the cancel free guide button 
.
Once all the free guide lines were properly marked by repeating the procedure, to end the free guide and save it in the current field, press the finish free guide button . The guide file will then be saved to GeoNave internal memory, and the line closest to the current GNSS coordinates will be displayed as a solid red line, as shown in the image below.
With the free guide defined, the side button bar on the right side of the navigation screen will show the button to view the current location on the free guide map 
. Pressing the button, the Current Map and Location screen will be displayed, as shown in the image below.
