6.1. Switching ON and OFF

Switching the GeoNave display ON

To switch ON the GeoNave display, after correctly following all the steps described in the Installation section, press the black button positioned on the display left side, as shown in the image below. A short beep will be heard, indicating that the system has been switched on.

The system initialization screen will appear, containing the manufacturer’s logo, then the loading screen for all system configurations is shown.

Finally, the system’s initial screen is shown, containing the three main menus – Information, Navigation and Settings.

Switching the GeoNave display OFF

The procedure for switching OFF the GeoNave display is equally simple. Press the black button positioned on the left side of the display, as shown in the image below.

A short beep will be heard and the following screen will be shown, including a 10 seconds countdown for automatic shutdown.

During the countdown:

• If the user does not press any key within 10 seconds, the system will automatically shut down.
• If the user presses the Confirm button , shutdown will occur instantly.
• If the user presses the Cancel button , the shutdown process ends and the system returns to the previous screen.
  

*When an event is open on the navigation screen, it is not possible to switch off the GeoNave through the black side button.

!Do not switch off the GeoNave display by disconnecting the power cables. There may be loss of information about the work in progress, in addition to electrical damage to the system.