6.2. Touch sensitive buttons

The GeoNave system screens have several types of touch sensitive buttons, each with specific functions on every type of screen. The following tables shows possible states that a button can assume on the screen and also a description of every button type.

Button states

Buttons can have 4 states, described in the table below with the example of point A marking button.

State	Image	Description
Normal		Normal button state, without been pressed by the user. Indicates also that the function activated by the button is not active.
Pressed		Button state while the user touches the screen.
Active		Indicates that the function activated by the button is active.
Flashing		Indicates the next action the user must take, by pressing the flashing button.

Button types

The following describes button types that can be found on the GeoNave system screens.

Configuration screen buttons

Button	Description
	Information menu
	Information > Satellites menu
	Information > Equipment menu
	Navigation menu
	Navigation > Build Field menu
	Navigation > Open Event menu
	Settings menu
	Settings > Spraying menu
	Settings > Work menu
	Settings > Auto Steering menu
	Settings > Fertilization menu
	Settings > Memory menu
	Settings > RTK Configuration menu
	Settings > Advanced menu
	Return to previous screen
	Go to the next screen
	Confirm a selection or setting
	Cancel a selection or setting
	Select the option above
	Select the option below
	Select the option on the left
	Select the option on the right
	Edit parameter value
	Increase parameter value
	Decrease parameter value
	Switch off parameter function
	View item information
	View item information
	Load file from pendrive to internal memory
	Delete file from internal memory
	Download file from internal memory to pendrive

Spraying navigation and simulation screen buttons

Button	Description
	Exit navigation or simulation
	Activate spraying
	Access spraying settings button pages
	Select fixed spraying rate 1
	Select fixed spraying rate 2
	Select manual spraying rate
	Select automatic section shut-off
	Select manual section shut-off
	Switch data in the information bar
	Access settings menu
	Edit parameter value
	Select above option; increase manual spraying rate
	Select below option; decrease manual spraying rate
	Select the option on the left
	Select the option on the right
	Change the button page
	Marks point A, or starting point, of a guidance
	Marks point B, or ending point, of a guidance
	Pause guide navigation
	Resume guide navigation
	Enter the position adjustment menu
	Start boundary marking
	Pause boundary marking
	Resume boundary marking
	Finish boundary marking
	Change to 2D view
	Change to 3D view
	Change zoom level
	Increase demo speed
	Decrease demo speed

Spraying section buttons

Spraying section buttons shown at the bottom of spraying navigation and simulation screens have a variable image width according to the sections number (1 to 9) and can assume the states shown below.

State	Description
	Section without overlap, switched on, applying
	Section without overlap, switched on, not applying
	Section without overlap, switch off
	Overlapping section, switched on, applying
	Overlapping section, switched on, not applying
	Overlapping section, switched off