EasyRoll Software / Advanced Dialog / Pin 2 Usage Tab /
Most Downstream Zone
Please note that by default and without any intervention, the most downstream zone will always try to discharge product. To control this, you need to utilize the Aux I/O Pin 2 signal for the most downstream zone as an Accumulate input.
Assuming the most downstream zone is connected to the right side of the module; we set the Right Aux I/O Pin 2 to Accumulate from the drop-down box and make sure we click the “DOWN” arrow to indicate that the Right Pin 2 signal is to be associated with the Downstream Zone. When the Right Pin 2 signal is energized, the downstream zone will stop when an item arrives on its sensor |
Post your comment on this topic.