Appendix /

Lane Full Interface	ConveyLinx ERSC ✅	ConveyLinx-Ai 24V ✅	ConveyLinx-Ai 48V ✅
	ConveyLinx-ECO ✅	ZPA Mode ✅	PLC I/O Mode ❌

A special case for the most downstream zone’s Interlock Input signal is referred to as Lane Full Interface. This is used when you want to simply continually discharge items onto non-ConveyLinx controlled conveyor/machine and by-pass the normal ConveyLinx ZPA singulation release functionality.

*Enabling the Lane Full Interface automatically Disables the Arrival Jam

*Helpful Tip: The Lane Full Interface works particularly well for pitched gravity conveyor lanes because EasyRoll+ includes block and clear timer settings just like you would have to use in a PLC program for a connected sensor. This feature allows you to use a standard sensor instead of a special sensor with integrated timers.

You set this up by connecting a sensor (or PLC output) to the most downstream zone’s Interlock Input and then selecting Lane Full Interface(DI) for the corresponding Interlock Input in EasyRoll+.
When the Interlock Input is energized, the ConveyLinx module module starts its Block Timer. During the period that the Interlock input is energized and the Block Timer is timing, items will continue to discharge from the most downstream zone
When the Block Timer expires, the most downstream zone will stop releasing.
When the Interlock Input is de-energized the ConveyLinx module module starts its Clear Timer. During this period when the Interlock Input is de-energized and the Clear Timer is timing, items will not release from the most downstream zone
When the Clear Timer expires, the most downstream will begin releasing items again