Offline System / Module Configuration Screen Tabs / ConveyMerge /


Merge Zone Module

ConveyLinx ERSC ConveyLinx-Ai 24V ConveyLinx-Ai 48V
ConveyLinx-ECO ZPA Mode PLC I/O Mode

Depending on the physical arrangement of actual zones on the Center Line, the Merge Zone can be assigned to either the Upstream or Downstream zone of its particular ConnveyLinx module. It can also be assigned to a ConnveyLinx module that is configured as a single zone ZPA controller.

In all 4 of these examples, Node 2 is the Merge Zone’s controlling ConnveyLinx module


Merge Zone on Upstream Zone


Merge Zone on Downstream Zone


Single Zone Module

Whenever an ConnveyLinx module has been Auto-Configured as a single zone; regardless of whether the single zone is connected to the right side or left side of the ConnveyLinx module, the logical designation for the zone on the this module is always the Upstream Zone. Shown below are examples of a single zone module using the left and right sides of the module respectively.

Merge Zone on a Single Zone Module's Left Side

Merge Zone on a Single Zone Module's Right Side

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment