vi. Adding Items With A Bluetooth Scanner

CONFIGURATION

Before getting started, we have to make sure that the ipad is paired with the scanner.

On the ipad tap on settings.

Tap on scanning.

Enable Use Bluetooth scanner , enable Auto Add to Order if you wish to do it on fast mode, disable otherwise.

ADDING ITEM with Auto Add to Order Mode enabled.( Fast Mode )

Adding an item with Auto add to Order mode enabled will make the iPad add an order just by scanning the item by minimum quantity.
To add an item, tap on the search box and then scan the bar code of the item. A confirmation should show that the item has been added and at the same time the iPad will also produce a distinctive success sound.

• If the item is already on the order
  The app will add the minimum quantity to the previous one allowing you to update the order. A yellow notification will pop with the update information along with a distinctive sound for an item update after scanning.
  

   

  
  

   

  
  

   

• If the item is not found

A red notification box will show up along with a distinctive failure sound after scanning the item.

*With a bit of practice you can be fully guided by the sounds.

REMOVING AN ITEM

To remove an item, tap on the scan option on the top right corner and then select remove item.

Make sure that status shows “ Remove items”.

Scan the item that needs to be removed, and a confirmation will show that the item has been deleted
successfully.

ADDING ITEM without Auto Add to Order Mode

Adding an item with Auto add to order mode disabled will make the iPad process an order just like the ordinary way of processing an order. After scanning an item, the Order screen will open, after finishing adding the information on the order just tap on Add to Order.

^{BarcodeApps © 2016}