iii. Pairing With A Bluetooth Scanner

This knowledge base article will guide users to pair a Bluetooth scanner on the iPad device.

BP101 BLUETOOTH SCANNER

Before getting started, the standard Bluetooth scanner that we recommend is the BP101 scanner which is tested and compatible to work with the PRISM App.

To Pair the socket BP101 Bluetooth scanner. we have to make sure that the scanner is not paired to any device.

DE PAIRING SCANNER

Scan the Restore defaults barcode and UART 9600 barcode to depair the device.

PAIRING SCANNER

Now the scanner is depaired.

• Press the trigger to start the scanner, If the red light is flashing the scanner is in search mode.
• If not scan the barcode below (called Pair) or hold the trigger for 8 seconds to enter pairing mode.

Go to the iPad settings window.

Tap on Bluetooth and then wait for the iPad to detect the scanner.

Once you have the scanner detected, tap on the scanner and wait for the status to say connected.
on the scanner you will hear a double beep and the red light will go off and be replaced by a blue light.