Setup a Scan Station

Start by following the instructions in the Install the RVI PC Viewer section.

Once the RVI PC Viewer is installed and the EHLLAPI is setup. Install the scanner driver. If you are running Kofax VRS, you will need to install the ISIS driver then Kofax VRS. If you are not running Kofax VRS, you will need to install the Twain driver.

*A licensed copy of Kofax VRS is required for barcode scanning. Kofax VRS can be purchased directly from Kofax at www.kofax.com or by calling 949-727-1733. Kofax is also available through resellers. RVI recommends contacting the company you purchased your scanner from for information on purchasing Kofax VRS.

• Open the RVI PC Viewer.
• Navigate to Image/Preferences/Scanner Support to setup the Default Scanner.
  • For Kofax/ISIS scanners, check the box labeled Load Kofax Scanners
  • For Twain scanners, check the box labeled Load TWAIN Scanners
• Select your scanner from the Default Scanner drop down list.

The list of scanners is based on the drivers installed on the pc. If you do not see your scanner listed, verify Windows recognizes the scanner in Device Manager.

Once the scanner is setup in the RVI PC Viewer, you are ready to scan from OneLook using the Scan Using Indexes Above Scan Using A Profile options.

Copyright 1992, 1999, Real Vision Software, Inc. (RVI), Alexandria, Louisiana. No part of this document may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language in any form or by any means without the express written consent of RVI Software, P.O. Box 12958, Alexandria, LA 71315-2958. However, copies of the One Look Manual can be reproduced, in whole or part, for use with the Real Vision Imaging System by Real Vision Software Licensee’s, for use with the imaging system.