Create Action Codes

1. From an IBM i command line, type GO IMAGE

*RVILIB must be in your library list. To add RVILIB to your library list, type ADDLIBLE RVILIB from an IBM i command line.

2. Select 6: Image Management Menu

3. Select 5: Rubber Stamp Action Codes

4. Specify the desired number (0-9) for the new action code.
   To see a list of existing action codes, press < Enter >

5. Specify the Description of the action code.
   The Description is the value seen in the Que Up Approval action codes drop down list.

The new action code will be added to the IBM i table.

The action codes drop down list in the Que Up Approval window will update to reflect the new code.

Copyright 1992, 1999, Real Vision Software, Inc. (RVI), Alexandria, Louisiana. No part of this document may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language in any form or by any means without the express written consent of RVI Software, P.O. Box 12958, Alexandria, LA 71315-2958. However, copies of the One Look Manual can be reproduced, in whole or part, for use with the Real Vision Imaging System by Real Vision Software Licensee’s, for use with the imaging system.