To add a user to the directory:

  • Type GO MAIN on the IBM i command line
  • Option 11 IBM i Access tasks
  • Option 21 Enroll IBM i Access users

You will then see the following screen:

Enter the user’s IBM i profile/user id. Normally these are one in the same. You have the option of entering a user description. Make sure ‘Add to system directory’ is set to *YES. When you press enter, a message will appear at the bottom of the screen stating the user has been enrolled.


Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment